Fujitsu MB91460 Series Application Note page 46

If your programming software needs connection of RTS and CTS or if it generates reset
signal on RTS or DTR line, refer to the following jumper list:
Jumper
JP32 (RTS-CTS)
JP4 (UART"A"/"B")
JP5 (DTR / RTS "B")
JP24 (Main Reset)
JP35 (Polarity)
Table 19: Jumper settings for reset signal on starterkit SK-91465K-120PMT
JP24
JP5
JP32
Figure 42: Jumper setting on starterkit SK-91465K-120PMT
MCU-AN-300012-E-V13
Serial Asynchronous Flash Programming
Chapter 8 SK-91465K-120PMT
Setting Description
Closed RTS and CTS of X5 are connected
Open RTS and CTS of X5 are not connected
2-3 UART"B" is used to generate Reset
1-2 DTR of UART"B" is selected
2-3 RTS of UART"B" is selected
Closed External Reset generation is active
1-2 No negation for the DTR/RTS signal
2-3 DTR/RTS signal is negated
JP35 JP4
X5/UART "B"
- 44 -
JP6/8
© Fujitsu Microelectronics Europe GmbH