Galep-Programmer; Galep-4 - Fujitsu MB91460 Series Application Note

Serial Asynchronous Flash Programming
Chapter 4 GALEP-Programmer

4 GALEP-Programmer

This chapter explains the usage of the 'GALEP-4' and 'GALEP-5' programmer for serial
synchronous/ asynchronous programming and parallel programming of the MB91460 series
flash devices.

4.1 GALEP-4

GALEP-4 Programmer is a third party tool developed by 'Conitec' (www.conitec.com).
This programmer allows parallel as well as serial programming of several Fujitsu
microcontrollers.
In case of parallel programming, different socket-adapters are available, depending on the
microcontroller family and device package.
In case of serial programming both synchronous and asynchronous modes are supported.
For serial-synchronous programming an optional ISP-adapter is offered. For serial-
asynchronous programming the programmer itself behaves like a dongle, the programming
is done directly via the PC's COM-port connected to the microcontroller.
The GALEP-4 is a PC-controlled programmer using the parallel-port (LPTx). It can be
powered by an external power-supply (12V, 400mA) but also by accumulators (6x Type AAA
NiMh 1.2V).
Figure 14: Conitec GALEP-4 Programmer
Software used together with the GALEP-4 programmer is GALEP32. This software supports
all programming modes available for the adequate device.
Figure 15: GALEP32 programmer software
MCU-AN-300012-E-V13 - 20 - © Fujitsu Microelectronics Europe GmbH