Fujitsu MB91460 Series Application Note page 39

Table 7 shows the default settings for UART4 with connector 'UART A'.
Jumper
ST1300 – Pin 1
UART "A": SOT
ST1303 – Pin 1
UART "A": SIN
ST1009
UART/LIN "A"
If your programming software expects connection of RTS and CTS signal, close jumper
ST1007. Connection does not support a reset of microcontroller via RTS or DTR signal.
Jumper
ST1007
UART "A": RTS-CTS
UART A
ST1009 ST1007
Figure 35: Jumper setting for connection with main board
© Fujitsu Microelectronics Europe GmbH
Serial Asynchronous Flash Programming
Chapter 6 SK-91460-MAIN with SK-91460-91F467D-208PFV
Setting
ST1301 - Pin 4
ST1304 - Pin 4
1-2
Table 12: Jumper setting for connection on main board
Setting
ON (closed)
OFF (open)
Table 13: Additional jumper setting on main board
Description
UART "A" is connected to SOT 4
UART "A" is connected to SIN 4
LIN/UART "A" uses the RS232 output
Description
RTS and CTS is shortcut on UART "A" / SL1000
RTS and CTS is not shortcut
UART 'A'
UART 'B'
UART 'C'
UART 'D'
SOT
- 37 -
UART1
UART2
UART3
UART4
.
.
UART15
SIN
MCU-AN-300012-E-V13
LIN 'A'
LIN 'B'
LIN 'C'
LIN 'D'