Sk-91469G-256Bga - Fujitsu MB91460 Series Application Note

Serial Asynchronous Flash Programming
Chapter 9 SK-91469G-256BGA

9 SK-91469G-256BGA

This chapter describes the needed settings for programming the MB91F469G on the
starterkit SK-91469G-256BGA.
The starterkit SK-91469G-256BGA is a multifunctional development board for the FUJITSU
32bit flash microcontroller MB91F469G in BGA256 package. It can be used stand-alone for
software development and testing or together with a monitor debugger software.
The board allows the designer immediately to start software development before his own
final target system is available.
Figure 43: Connection to starterkit SK-91469G-256BGA
For serial asynchronous programming SUB-D9 connector X2 which is connected to UART4
has to be used. Following jumper setting is needed:
© Fujitsu Microelectronics Europe GmbH - 45 - MCU-AN-300012-E-V13