Sk-91467C-144Pmc - Fujitsu MB91460 Series Application Note

14 SK-91467C-144PMC

This chapter describes the needed settings for programming the MB91F463C, MB91F465C
or MB91F467C on the starterkit SK-91467C-144PMC.
The SK-91467C-144PMC is a multifunctional evaluation board for the Fujitsu 32bit flash
microcontroller MB91F463C, MB91F465C and MB91F467C in LQFP100 package. It
supports also MB91F465B, MB91F467B and MB91F464H if the external bus interface is not
used. The board is used stand-alone for software development and testing.
For serial asynchronous programming SUB-D9 connector X6/UART "A" which is connected
to UART4 has to be used. Following jumper setting is depending on the used device
needed:
Jumper
JP48
JP49
Table 30: Jumper setting on starterkit SK-91467C-144PMC
© Fujitsu Microelectronics Europe GmbH
Serial Asynchronous Flash Programming
Chapter 14 SK-91467C-144PMC
Figure 57: Connection to starterkit SK-91467C-144PMC
Setting Description
1 - 2 SIN4 of MB91F46xC is connected to UART"B"
2 - 3 SIN4 of MB91F46xB is connected to UART"B"
1 - 2 SOT4 of MB91F46xC is connected to UART"B"
2 - 3 SOT4 of MB91F46xB is connected to UART"B"
- 59 - MCU-AN-300012-E-V13