Fujitsu MB91460 Series Application Note page 19

Press button "Initialize". If the command prompt of the flash loader is received, all the flash
loader functions become enabled. See table 3 for a short description of each function.
MB91460 series devices do not support "Autodetect" function!
Function
Initialize
Blank Check
Chip Erase
Sector Erase
Call
Read
Prog 32bit
Read to File
Prog File
To program user application to the flash memory browse to correct mhx-file and use "Prog
File" function. After successful programming press "Disconnect" button to close COM port.
For further information on the FME-Flash Programmer software please refer to the user
guide.
© Fujitsu Microelectronics Europe GmbH
Serial Asynchronous Flash Programming
Chapter 2 FME-FR Programmer
Description
Checks if the flash loader, which was dumped to RAM, is
available, initialized at the correct baudrate and ready to
operate. This function checks for a prompt character (">"). If this
operation fails (e.g. no flash loader present), none of the
following functions will be enabled.
Reads out every byte of each flash-sector to check for non-
blank cells. The result is displayed in the flash-diagram on the
right side (red = not blank sectors; green=blank sectors).
Erases the entire flash-ROM (all sectors).
Erases one sector indicated by the sector number.
This function will divert operation of the device to the specified
location. This terminates the flash loader.
Reads out a given number of bytes beginning at the specified
address and displays the results in hexadecimal format on the
log-window.
Programs one word to flash at the specified address.
Reads out the Flash content and writes to the given bin-file.
Handles the transfer of the specified MHX-file to the flash
loader.
Table 4: Flash Loader Functions of FME-FR Programmer
- 17 - MCU-AN-300012-E-V13