Fujitsu MB91460 Series Application Note page 60

If your programming software needs connection of RTS and CTS or if it generates reset
signal on RTS or DTR line, refer to the following jumper list:
Jumper
JP24
JP72
JP28
JP14
JP33
Table 29: Jumper settings for reset signal on starterkit SK-91465X-100PMC
JP14
JP24 JP28
MCU-AN-300012-E-V13
Serial Asynchronous Flash Programming
Chapter 13 SK-91465X-100PMC
Setting Description
Closed RTS and CTS of X5 are connected
Open RTS and CTS of X5 are not connected
1-2 UART"A" is used to generate Reset
1-2 DTR of UART"A" is selected
2-3 RTS of UART"A" is selected
Closed External Reset generation is active
1-2 No negation for the DTR/RTS signal
2-3 DTR/RTS signal is negated
JP72
X5/UART "B"
Figure 56: Jumper setting on starterkit SK-91465X-100PMC
JP33
JP29
JP26
- 58 - © Fujitsu Microelectronics Europe GmbH