Fujitsu MB91460 Series Application Note page 54

Jumper
JP81
JP82
JP86
Table 24: Jumper setting on starterkit SK-91467R-176PMC
If your programming software needs connection of RTS and CTS or if it generates reset
signal on RTS or DTR line, refer to the following jumper list:
Jumper
JP88
JP87
JP80
JP51
JP53
Table 25: Jumper settings for reset signal on starterkit SK-91467R-176PMC
MB91F467R needs a special mode pin setting for entering programming mode. Therefore
set Dip Switch S1 (Mode Switch) for serial programming: (0,1,0,0) and press reset button
before starting programming sequence:
Dip-Switch S1
(programming mode)
Figure 50: Mode Pin setting for programming mode on SK-91467R-176PMC
MCU-AN-300012-E-V13
Serial Asynchronous Flash Programming
Chapter 11 SK-91467R-176PMC
Setting Description
1-2 closed SIN0 is connected to RS232 transceiver
1-2 closed SOT0 is connected to RS232 transceiver
1-2 closed X2 Pin 4/6 is connected to RS232 transceiver
Setting Description
closed RTS and CTS is shortcut at connector X2
open RTS and CTS is not shortcut at connector X2
1-2 closed DTR can be used for system reset
2-3 closed RTS can be used for system reset
closed Reset will be done via UART0
1-2 closed No polarity inversion for the DTR/RTS signal
2-3 closed Polarity inversion for the DTR/RTS signal
Closed External reset generation is active
MD3 MD2 MD1 MD0
1
- 52 -
ON
OFF
2 3 4
© Fujitsu Microelectronics Europe GmbH