Fujitsu MB91460 Series Application Note page 51

If your programming software needs connection of RTS and CTS or if it generates reset
signal on RTS or DTR line, refer to the following jumper list:
Jumper
JP32
JP4
JP5
JP35
JP24
Table 23: Jumper settings for reset signal on starterkit SK-91463N-64PMC
MB91F463N needs a special mode pin setting for entering programming mode. Therefore
set Dip Switch S2 (Mode Switch) for serial programming: (0,0,1,0) and press reset button
before starting programming sequence:
Dip-Switch S2
(programming mode)
Figure 46: Mode Pin setting for programming mode on SK-91463N-64PMC
Please note to set mode pins back to run mode (0,0,0,0) after successful programming:
Dip-Switch S2
(Run mode)
Figure 47: Mode Pin setting for run mode on SK-91463N-64PMC
© Fujitsu Microelectronics Europe GmbH
Serial Asynchronous Flash Programming
Chapter 10 SK-91463N-64PMC
Setting Description
closed RTS and CTS is shortcut at connector X5
open RTS and CTS is not shortcut at connector X5
2-3 closed UART B is used to generate reset
1-2 closed DTR can be used for system reset
2-3 closed RTS can be used for system reset
1-2 closed No polarity inversion for the DTR/RTS signal
2-3 closed Polarity inversion for the DTR/RTS signal
Closed External reset generation is active
MD0 MD1 MD2 MD3
1
MD0 MD1 MD2 MD3
1
- 49 -
ON
OFF
2 3 4
ON
OFF
2 3 4
MCU-AN-300012-E-V13