Table of Contents
Advertisement
Perform Maintenance after Use
After use, be sure to clean the liquid material vat and printing platform.
Perform this task with all power switches left switched off.
WARNING
Otherwise sudden movement of the machine may cause injury.
Be sure to perform operations as specified by the instructions below, and never touch any area not specified in the instructions.
WARNING
The machine may move in an unexpected way, resulting in injury or burns.
Never place a photo-curable resin container in fire.
WARNING
Resin may flow out, catch fire, and spread fire to other nearby objects.
Never use gasoline, thinner, or such material.
WARNING
Doing so may cause fire.
When handling resin, wear rubber gloves.
CAUTION
Do not allow resin to come into contact with the skin or eyes.
NOTE
•
After printing completes, do not allow resin to remain in the liquid material vat. Also remove any adhering resin. Allowing the resin to remain in the liquid
material vat can cause the vat to deteriorate and can lead to printing failure.
•
Be sure to remove any resin adhering to the printing platform. Allowing the resin to remain can cause the printing platform to deteriorate and can lead to
printing failure.
•
Also be sure to remove all the resin that has adhered to the work tray. Allowing the resin to remain can cause the work tray to deteriorate to the point where it
can no longer be used.
•
When using ethanol for maintenance, only use it where instructed. Failure to do so may result in color changes or deformation.
•
Be careful of fire when using ethanol.
45
Corresponds to
[monoFab Player AM Ver.1.40]
Output (Printing)
or later
Advertisement
Table of Contents
