Table of Contents
Advertisement
Symptom
Points to check
Is the bottom of the liquid material vat dirty
or cloudy?
The job does not solidify
Has the projector reached the end of its
service life?
Is the bottom of the liquid material vat dirty
or cloudy?
The job does not attach
to the printing platform
(it remains in the liquid
material vat)
Is the surface of the printing platform dirty?
Is it scratched or deformed?
Has the initial printing height of the
printing platform been adjusted?
Is the bottom of the liquid material vat dirty
or cloudy?
Is there enough resin in the liquid material
The job is chipped (it is
vat?
not a complete shape)
Is there a problem with the angle of the
machine?
Is the object contained within the work
area?
Action
Use different liquid material vats depending on the type of resin you are
using.
If the liquid material vat is dirty, wash it.
Set the non-cloudy part of the bottom of the liquid material vat toward
the back of the machine.
Alternately, replace the liquid material vat with a new one.
It is recommended that you replace the projector.
Use different liquid material vats depending on the type of resin you are
using.
If the liquid material vat is dirty, wash it.
Set the non-cloudy part of the bottom of the liquid material vat toward
the back of the machine.
Alternately, replace the liquid material vat with a new one.
If the printing platform is dirty, wash it.
If it is scratched or deformed, replace it with a new printing platform.
Appropriately adjust the initial printing height.
Use different liquid material vats depending on the type of resin you are
using.
If the liquid material vat is dirty, wash it.
Set the non-cloudy part of the bottom of the liquid material vat toward
the back of the machine.
Alternately, replace the liquid material vat with a new one.
The machine cannot print if there is no resin in the printing part of the
liquid material vat. Check that there is enough resin left for printing.
It is necessary to position the machine on an angle so that the
remaining resin collects in the printing part (the back of the liquid
material vat) even as the amount of resin decreases during printing. For
information on how to set up the machine and check the angle, refer to
"Roland DG Start-up page"
the
Areas of data that extend outside the work area will not be printed.
Check that the data is contained within the work area.
56
Refer to
p. 22
p. 49, p. 53, p. 54
p. 54
p. 22
p. 49, p. 53, p. 54
p. 46, p. 54
p. 26
p. 22
p. 49, p. 53, p. 54
p. 29
"Roland DG Start-up page"
http://startup.rolanddg.com/
p. 39
Corresponds to
[monoFab Player AM Ver.1.40]
Appendix
or later
Advertisement
Table of Contents
