Table of Contents
Advertisement
Adjust the Initial Printing Height (Z0)
When setting the liquid material vat for the first time or when replacing the liquid material vat, it is necessary to adjust the height at which the job starts to be made
in the liquid material vat.
1.
Using the included
"hexagonal wrench,"
Loosen each screw so that around 2 mm of the shaft is visible, and check that it is possible to move the printing platform up and down by hand.
NOTE
Always loosen the Z0 adjustment screws. If you proceed to step 2 without loosening the Z0 retaining screws, a large load will be applied to the liquid material vat,
printing platform, and Z axis unit, which may result in damage.
loosen the Z0 adjustment screws (4 locations).
Z0 adjustment screw
(Both sides of printing platform: 4 locations)
26
Corresponds to
[monoFab Player AM Ver.1.40]
Output (Printing)
or later
Advertisement
Table of Contents
