TEC FS-1450 Owner's Manual page 21

7.2. CASHIER KEY METHOD (Hardware Option)
When the [LOG/RECEIPT] (or [LOG]) key is not installed, the Push-stay Cashier Keys may be pro-
vided at the side of the Mode Lock:
Push-stay Cashier Locks and Keys
Cashier Keys 1 to 4
Each key is assigned to each cashier. The register will not operate in the "REG", "MGR", or "
unless one of these keys is inserted and pushed on or pushed-and-locked at the corresponding Cashier
Lock. The light is lit when the key is in the ON-status.
Each of the keys may be inserted and pulled out in the neutral position marked with "1" to "4" in the
above figure, and two ways are provided to set the Cashier Key to ON status:
PUSH-ON
When simply pushed on and released, the Cashier Key is set to ON status. This ON condition will
be cleared by any of the following conditions:
1) when no key-in operations follow in three seconds.
2) when the transaction is finalized.
3) when another Cashier Key is pushed-on when outside a sale.
4) when the Mode Lock is turned to another position.
PUSH-AND-LOCK
When pushed and turned to the right, the ON status is locked until it is turned back to release and
another Cashier Key is set to ON.
When another Cashier Key is attempted to push-and-lock, the register will entirely be locked.
If a Cashier Key has already been set to ON and a sale is under way, another Cashier Key will be
disregarded if attempted to ON.
Under the CASHIER KEY METHOD, no receipts are issued, nor will the drawer open by setting a
cashier key to the ON status.
The multi-drawer feature may be taken with the Push-stay Cashier Keys. In this case, each of the
drawers 1 and 2 are assigned to Cashier 1 and Cashier 2, respectively. (No drawers for Cashiers 3 and
4.)
The "SIGN ON" triangular lamp will not be lit in any occasion under the cashier key method. The light
attached to each Cashier Lock will be lit instead.
Cashier Locks 1 to 4
– 15 –
EO1-11097
Light to indicate
ON-status
" mode