Table of Contents
Advertisement
11. JOURNAL AND RECEIPT PAPER-END
DETECTOR
(1)
This detects when either the journal or receipt paper is coming near the end. It is provided in order
to prompt the operator to replace the old paper roll with a new one.
(2)
When the paper roll comes near the end (or the paper has not been set properly), no key operation
will be accepted and the AMOUNT portion of the display will keep flickering.
(3)
When a new paper roll is set, only the [RF] and [JF] keys are allowed to operate. Next, when the [C]
key is depressed, the display flickering will be cleared and normal key-in operations will be accepted.
If any printing was suspended, it will continue printing.
(4)
If this detector senses a paper-end condition during printing, the printing will stop after the current line
printing is completed.
(5)
If the [C] key is depressed in the paper-end condition, it will be ignored. The [C] key depression will
be effective to clear the display flickering only after the new paper roll is set.
(For further details, refer to Chapter 15.)
12. ECR PRINTER MOTOR LOCK DETECTOR
(1)
This detects the printer motor lock condition caused by some trouble.
(2)
When such a condition is detected, the front display indicates "Error" and none of the keys (including
[RF] and [JF]) will be accepted.
(3)
To regain the normal condition, turn the power of the ECR to OFF, remove the cause of the motor
lock, and then turn the power to ON again.
13. GUEST CHECK PRINTER MOTOR LOCK
DETECTOR
(1)
This detects the guest check printer motor lock condition caused by some trouble.
(2)
When such a condition is detected, the front display indicates "Error" and none of the keys (including
[RF] and [JF]) will be accepted.
(3)
To regain the normal condition, turn the powers of the ECR and the guest check printer to OFF,
remove the cause of the motor lock, and then turn the powers to ON again.
* If the cause cannot be found in the guest check printer and only the ECR may be required to work
temporarily without the guest check printer, remove the guest check printer cable from the ECR, and turn
the power of the ECR to ON.
14. PRINTER GUIDE OPEN DETECTOR
(1)
This detects the printer guide open condition.
(2)
When such a condition is detected, the front display indicates "Error" and none of the keys (including
[RF] and [JF]) will be accepted.
(3)
To regain the normal condition, turn the power of the ECR to OFF, close the printer guide, and then
turn the power to ON again.
- 59 -
EO1-11097
Hide quick links:
Advertisement
Chapters
Table of Contents
