Validation Print; Recall Entry - TEC FS-1450 Owner's Manual

RECALL ENTRY

This operation recalls a order table.
OPERATION
| Order No. | [RECALL]
NOTE: Recall Entry can be canceled.
To end the entry, follow the procedure described below.
[RECALL]

VALIDATION PRINT

OPERATION
After entering the required
item through a transaction
key or media key. ( NOTE 1 )
NOTES: 1. If the "SLIP" lamp flickers during registra-
tions, it indicates that the last item just
entered is programmed to require valida-
tion print. In this case, no other opera-
tions can follow until the validation print of
the item is first executed.
2. Because printing occurs on the front side
of the slip, please be certain to insert the
slip into the validation with the printing
side frontward.
3. No other operations can follow until the
validation slip once printed is withdrawn.
4. The following are programmable selec-
tions relating to validation:
(1) PRINT FORMAT
a) Date Print/Non-print
b) Consecutive No. Print/Non-print
c) Cashier No. Print/Non-print
(2) MULTI- or SINGLE-VALIDATION (Number of times of validation print allowed for the
same item)
(3) VALIDATION COMPULSORY status on Media Keys and other transaction keys.
5. When the sale-finalizing media key is programmed with Validation Compulsory status and
the key is used with over-tendering, the drawer will open on the compulsory validation print.
6. When the sale-finalizing media key is programmed with Validation Compulsory status and
the key is used with equal-tendering or used as Total key, the drawer will open even if the
status "Not Open" is programmed on the key.
Sale finalization
Additional order entry
[ITEM CORR]
[ALL VOID]
Insert a validation slip into
the validation slot. make
sure that the "SLIP" lamp is
steadily lit. ( NOTE 2 )
[TOTAL]
Sale finalization
[AT/TL] (or other media)
[ITEM CORR]
Validation Slot
– 55 –
EO1-11097
[VALIDATE]
Validation Slip