6. PROGRAMMING OPERATIONS
This chapter is provided for the store programmer or the store manager who may have to change the
programmed data of the FS-1450 series ECR on the daily, weekly, or monthly basis. Usually, all the
basic program data required for your store should be set before delivering the product by your local
TOSHIBA TEC representative. However, in need of changing or adding program data, please refer to
this chapter. It is also recommended to read the OPERATOR'S GUIDE as well as other chapters of the
MANAGER'S GUIDE in order to thoroughly understand the descriptions in this chapter. If there are any
unclear points or program data other than listed here must be changed or added, please contact your
TOSHIBA TEC representative.
-- CHARACTER ENTRIES -- ................................................................................................................ 28
Submode No. 1:
Submode No. 2:
Submode No. 4:
Submode No. 5:
Submode No. 6:
Submode No. 8:
Submode No. 20: SALESPERSON CODE AND NAME PROGRAMMING ....................................... 48
Submode No. 27: PLU PRESET- CODE KEY SETTING ................................................................... 50
Submode No. 35
Submode No. 42
No Submode No.: DEPARTMENT PRESET PRICE SETTING OR CHANGING ............................... 54
GST RATE SETTING ............................................................................................ 65
TABLE OF PROGRAMMING OPERATIONS
- 26 -
EO1-11097
(page)
55