Sales Memory Clear - TEC EO1-11115 Owner's Manual

Sales Memory Clear

The operation defined as "Sales Memory Clear" will only clear the sales data accumlated in the register's
memory (report memory). The programmed data will not be cleared. By operating a Sales Memory Clear
, all the sales data including non-resettable totals and counters, Reset Report Counts, Receipt Consecutive
No., and Electronic Journal memory are cleared.
Warning: This clear operation deletes all sales data stored in the register's memory.
Operating Procedure
Condition: Any time, outside or during any operation sequence except during Key Setting or Key Location
Changing or System Option Setting procedure.
Operation:
Use the S Key to turn the
Control Lock to "BLIND".
Depress the following Numeric Key according to the display and print format for zero amount:
Numeric Key
1
3
Depress the
A Sales Memory Clear receipt is issued.
NOTE: When a Sales Memory Clear is operated, the condition "after all sales data reset" is obtained, just as
"Status Clear" or "All Memory Clear". Therefore, no Reset Reports need to be taken for starting any
programming operation.
REG
OFF
SET
Zero-amount
Format
. 0
0 . 0 0
AT/TL
key.
Sales Memory Clear Symbol Line
(03 for Numeric 3, 01 for Numeric 1)
Receipt Consecutive No. is reset
to 0001.
(Date and Time remain unreset.)
X
Z
(BLIND)
for use in US or Canada
- 105 -
MA-186-100 SERIES
Thank you
Call again
05.- 28.- 9 7
0 3 0.0 0
0 00.1
1 3 - 0 4
Zero-amount Display & Print Format
designated here.
EO1-11115