TEC EO1-11115 Owner's Manual page 41

Department LC (Listing Capacity) Programming:
The LC setting is used to check an amount limit error. By setting the LC, an amount entry (due perhaps
to a mistake by the operator) will be prevented at the earliest stage (i.e., an error will result on entering
an excessive amount through the department key).
Condition: After Daily Financial Reset (refer to "NOTE on Condition" on page 15)
Programming Procedure:
Use the MA Key to turn the Control Lock to "SET".
X
REG
Z
OFF
SET
Declaration of Program No. 8 for Department LC programming
Repeat for setting LCs of other departments.
2-digit LC code for
each department
3
ex.)
NOTES: 1. If the individual LC of a department is set, it prevails over the common LC for all departments.
2. To reset a LC once set, enter "0" in place of the 2-digit LC code. Then a maximum of 7-digit amount
can be entered in sale entries.
Department LC Program Receipt Format:
Key Operation
Control Lock: SET
7
9
5 4
8
@/FOR
8
To designate the
Department
Nos. 21 to 40.
DPT
( )
SHIFT
NOTES 1, 2
4
.......... indicates $ 39.99 .......... Allows to enter equal to or smaller than
4 digits
Value of the top digit
@/FOR
8
3 Dept. 1
Dept. 2
4
Dept. 3
Dept. 4
0
AT/TL
6
Dept.
$39.99 in sale entries.
Thank you
Call again
05.- 28.- 9 7
0.8
0 1 7 3
0 2 9 4
0 3 5 7
0 4 0 0
8 6
0 01.1
0 8 - 5 2
- 35 -
MA-186-100 SERIES
AT/TL
Common 2-digit LC code for
NOTES 1, 2
all departments
Listing Capacity Code
Top digit value
Number of
maximum digits
for each department
Common LC for all departments
EO1-11115