Table of Contents
Advertisement
First, completely install the system, then connect it to voltage !
!
V1 and V2 must not be connected with P-, a- or b-wire.
When connecting the video wires V1 (+) and V2 (-) the polarity has to be observed.
In case of a distorted image after the commissioning, switch off the device and
change the wires for the video signal.
Presets ex works
The video indoor station is equipped with an EEPROM, in which the following device set-
tings are stored.
Preset times
communication time
image switch time
flashing period of the red LED, if
„video-/speech channel is busy" when
pressing the speech or image button
internal standby time
AS-address dependent image activation
If there are not only video front-door stations but also front-door stations without camera
within one system, the image is not activated, when a call arrives from these front-door
stations.
In order to guarantee this function, all possible AS-addresses are separated into two
areas:
AS-address 0 – 31*
AS-address from 32
* The limit of the AS-address areas can be adjusted ex works if required.
Note:
The AS-addresses of the front-door stations should be allocated via Service Device.
For more information see service information within the TCS Installer 5 / 4 (version 1) or TCS Installer 7 / 4 (version 2).
TCS TürControlSysteme AG
Mail: info@tcsag.de
12
Commissioning
Settings
reserved for video front-door sta-
tions
free, for front-door stations without
camera
max. 2 min
80 sec
3 sec
6 x flashing
around 2 min, if the device was called
around 30 sec, if the device is calling and
waiting for call acceptance
image is activated in case of
a door call
image is not activated in
case of a door call
Subject to technical changes.
PI_IMM2300_Art0031160-uk.doc
09/2011
Advertisement
Table of Contents
