Removing The Cover - IBM 8672-26x Manual

Removing the cover

Complete the following steps to remove the xSeries Hosting Appliance cover:
1. Review the information in "Safety" on page iii.
2. Turn off the xSeries Hosting Appliance and all attached devices and disconnect
3. Remove the two screws from the rear of the xSeries Hosting Appliance.
4. Pull out on the cover-release lever at the back of the xSeries Hosting Appliance
5. Slide the cover back, then up and off the xSeries Hosting Appliance.
Figure 4. Removing the cover
Continue with "Installing hard disk drives" on page 11 and "Installing memory" on
page 14.
10
IBM Eserver xSeries Appliances: Installation Guide for xSeries Hosting Appliance
all external cables and power cords.
to release the cover.
Attention: For proper cooling and airflow, replace the cover before turning
on the xSeries Hosting Appliance. Operating the xSeries Hosting Appliance for
extended periods of time (over 30 minutes) with the cover removed might
damage xSeries Hosting Appliance components.
Cover release
Screws
lever