Battery Charger - Juniper Mesa 3 Owner's Manual

Maintenance and Environmental Issues
Temperatures should be between 0°C to 50°C.
„
Avoid using the dock in situations where water can enter
„
the connector ports. It is not sealed against water and
must be kept dry.
Do not touch the docking pins (spring loaded contacts)
„
with conductive items when power is applied to the
dock.
Do not drop items on the dock that can damage the
„
pins.
Keep debris off of the docking pins.
„
The Mesa 3 docking pin contacts are always powered
„
on when it is docked. If you are using the Mesa 3 in a
potentially corrosive location when it is not docked, the
pin contacts can be turned off in Settings > Dock Control.

Battery Charger

The Battery Charger is an optional accessory, allowing you
to charge spare battery packs for the Mesa 3.
How to Use the Battery Charger
Batteries charge best at room temperature (about 68°F or
20°C). Batteries will not charge (or might charge slowly) at
temperatures below 32°F (0°C) or above 122°F (50°C).
Power the Battery Charger by using the AC wall charger
provided with your battery charger kit or your Mesa 3. Slide
the battery pack into the battery charger, orienting it so
that the battery contacts meet the charging contacts in the
battery charger. The red LED flashes slowly, indicating that
the battery pack is charging.
LED Indicator for Battery Pack
The LED indicates the charging status:
Solid, on: The battery pack is fully charged.
„
Blinking (slow): The battery pack is charging.
„
Off: There is no power. The battery is not charging.
„
34
Mesa 3 Rugged Tablet Powered by Android