Juniper Mesa 3 Owner's Manual page 28

Reading a Tag
Once the Barcode Connector utility is set up, you can start
scanning barcodes.
1. Leave the Barcode Connector utility running in the
background.
2. Open an application or document to receive the
barcode data and tap in the text field where you want
the data to be placed.
3. The barcode imager is located on the top of the Mesa 3
when in portrait mode. Aim the barcode imager at the
barcode.
4. The distance required between the barcode and Mesa
3 varies depending on the barcode being read. There
is a red aiming LED that helps you aim at the correct
barcode. Press the scan button (
time the application is opened). When the barcode is
successfully scanned, the barcode information is placed
in your application or document.
Troubleshooting the Barcode Imager
If the barcode imager is not functioning correctly, you can
use the following steps to set the imager to factory default
settings:
1. Launch the Barcode Connector utility.
2. Scan the Set Factory Default barcode shown here.
24
Mesa 3 Rugged Tablet Powered by Android
by default any