Table of Contents
Advertisement
Command Set
Testing
atatest
D
ESCRIPTION
S
YNTAX
P
ARAMETERS
E
XAMPLE
4 - 14
The following commands can be used to:
• Test the interface specified by setboot
• Perform basic binary tests to locate memory errors
• Perform memory read performance
• Perform memory write performance
• Perform memory read and write performance
Command to test the interface which is specified with the setboot com-
mand. Shows if a disk is present and its format.
atatest
None
PowerBoot> atatest
Testing ATA/IDE interface...
Found 2 devices on this ATA interface:
Device 0 type: ATA.
Device 1 type: unknown type.
Device 0 is the selected device for this run...
Soft Reset...
Seek, CHS, polling...
Seek, LBA, polling...
ATA Identify, CHS, polling...
ATA Identify, LBA, polling...
-Identify ATA/IDE device:
Signature
: 0x848A
Serial Number :
Model Number
: SanDisk SDCFB-64
Firmware Rev. : vdd 1.00
Buffer type
: 2 [0x2]
Buffer size
: 1024 [0x400]
Cylinders
: 490 [0x0]
Heads
: 8 [0x0]
Sect. p. track: 32 [0x0]
Capabilities
: 512 [0x200]
Number of sectors LBA : 60160 [0xEB00]
Number of sectors/card: 125440 [0x1EA00]
i5809080307
PowerBoot
PPC/CPCI-690
Advertisement
Table of Contents
