Figure 8 Button On Handle - Motorola PPC/CPCI-690 Reference Manual

Installation
From Basic Hot-
Swap System
From Full Hot-Swap
or High-Availability
System
Caution
PPC/CPCI-690
• Board damage
Touching the board or electronic components in a non-ESD protected
environment causes component and board damage.
Before touching boards or electronic components, make sure that you
are working in an ESD-safe environment.
The removal procedure depends on the system the board is to be removed
from.
1. Carry out software disconnection using system documentation
2. Wait until software disconnection process has been completed
3. Remove screws from front panel
4. Open handles
5. Remove board from peripheral slot of powered system
1. Remove screws from front panel
2. Press red button to unlock handles
Figure 8: Button on Handle
3. Open handles
The hot-swap switch will be opened automatically.
4. Wait until blue hot-swap LED is illuminated
Data loss
Removing the board from the backplane while the hot-swap LED is still
off causes data loss.
Therefore, wait until the blue hot-swap LED is on before removing the
board.
5. Remove board from peripheral slot of powered system
Board Installation
2 - 21