Table of Contents
Advertisement
PowerBoot
PPC/CPCI-690
Table 10: Setboot Options
Option
Description
RARP (Reverse
To select the protocol
Address Reso-
used to connect a server
lution) or ARP
to the board for auto-
(Address Reso-
boot. If you use RARP,
lution) protocol
set the IP in NIS.
Server-IP#
Protocol number which
selects the TFTP file
server. If you use the
internet protocol RARP,
the server IP# will be
ignored.
Target IP#
Set the board IP to define
the protocol number
identifying the board at
internet layer. If you use
the internet protocol
RARP, the target IP# will
be ignored.
Select boot disk
Boot disk to boot from
TFTP/ATA-IDE
Binary image name
boot file name
which will be down-
loaded via net or atapi
CompactPCI
Probe list for Compact-
bus probe list
PCI
Power-on self
To enable or disable the
test (POST)
power-on self test
Primary Booter
To enable or disable the
primary booter
Watchdog dur-
To enable or disable the
ing booting
watchdog during the
boot process.
Enable ECC
To enable or disable the
checking
SDRAM ECC option
Enable shared
To enable the Compact-
memory serial
PCI shared memory
communication interface
Booting the Board
Parameter
Required to be set
when Booting from
1: RARP
Net
2: ARP
aaa.bbb.ccc.ddd
Net; for use of ARP
protocol only
aaa.bbb.ccc.ddd
Net; for use of ARP
protocol only
-
ATA-IDE
image.bin
Net, ATA-IDE
8, 7, 6, 5, 4 , 3, 2
-
0: Enable
-
1: Disable
0: Disable
-
1: Enable
0:Disabled
Optional for all
1:Enabled
0: Disable
Optional for all
1: Enable
0: Disable
Only setup on
1: Enable
peripheral slot
4 - 7
Advertisement
Table of Contents
