Ipmi_Request - Motorola PPC/CPCI-690 Reference Manual

PowerBoot

ipmi_request

D
ESCRIPTION
S
YNTAX
P
ARAMETERS
HEX
E
XAMPLE
lo
D
ESCRIPTION
S
YNTAX
P
ARAMETERS
host
commands
offset
v
e
PPC/CPCI-690
Command to send values to the IPMI controller and display the response.
ipmi_request <HEX> [<HEX>][<HEX>] ...
Values in hexadecimal format
PowerBoot> ipmi_request 18 01
1c 01 00 01 81 63 84 01 5f 48 0e 00 04 08
PowerBoot>
This command loads S-records from the console port to the absolute
addresses of the memory which are specified by the S-records. The transfer
speed is 9600 bit/s with 1S8D1S (1 start bit, 8 data bits, 1 stop bit) data size.
No handshake protocol is used. Five tasks can be carried out:
• Loading S-records from the console port to the memory
• Modifying the storage address while loading S-records from the console
port to the memory
• Verifying the S-records
• Modifying the storage address while verifying the S-records
• Displaying the number of errors which occurred during the last loading
lo [<offset>] [v] [e] [<host commands>]
Specifies a list of commands that will be sent to the host to initiate the data
transfer
Specifies the value added to the absolute addresses of the S-records. This
allows to modify the storage address while loading or verifying.
Verifies the S-records, i.e. no data is loaded to the memory, but the memory
contents and the S-records are compared
Displays the number of errors occurred during the last loading
Command Set
4 - 41