Table of Contents
Advertisement
Installation
Installation in a Nonpowered System
Installation Procedure
Caution
PPC/CPCI-690
As a universal hot-swap board, the CPCI-690 can be installed in both 3.3V
and 5V systems.
Note: Before installing the board install the upgrades and accessories, if
necessary (refer to "Hardware Upgrades and Accessories" page 2-8).
1. Turn off system power
Board damage
Touching the board or electronic components in a non-ESD protected
environment causes component and board damage.
Before touching boards or electronic components, make sure that you are
working in an ESD-safe environment.
2. Check switch settings for consistency (see "Switch Settings"
page 2-13)
3. Open handles
4. PSB variant: Install board into node slot
Standard CompactPCI variant: Install board depending on
intended function either in system slot marked with a triangle or
in peripheral slot marked with a circle
5. Press handles inwards to lock board on rack frame
6. Fasten board with screws
7. Connect interface cables to front panel connectors, if applicable
8. Turn on system power
Board Installation
2 - 17
Advertisement
Table of Contents
