Playback - Technics SX-PR54/M Operating Instructions Manual

Part IV
PITCH POINT:
The pitch at which the pattern progression
sound is lowered by one octave.
• When the root note of the specified chord is higher than
the set pitch point, the pitch of that part is automatically
lowered by one octave, thus avoiding an unnaturally high
accompaniment pitch.
• This is effective only for the part for which the Melody
group was selected in CHORD MODIFY CHANGE.
SOUND:
Use the panel buttons to select the sound.
DIGI EFF:
Set the DIGITAL EFFECT to on or off.
• (SOUND) is the initialized setting of the sound.
<PAGE 2>
BALANCE:
Adjust the volume balance.
PAN:
Adjust the stereo balance of each part (LEFT
64 – CENTER – RIGHT 63).
• At "LEFT 64", the sound is all the way to the left, at
"RIGHT 63" all the way to the right. The center point is
CENTER.

Playback

1.
In the RHYTHM GROUP section, press the
MEMORY button.
RHYTHM GROUP
FUNK &
METRONOME POP ROCK SOUL
8 BEAT 16 BEAT USA
BALLROOM
DISCO POP BALLAD BALLAD & SHOW
WALTZ JAZZ & LATIN &
& TRAD SWING WORLD MEMORY
LOAD
REV:
Depth of the REVERB (0 to 127).
CHO:
Depth of the CHORUS (0 to 127).
BEND RANGE:
Adjust the range of pitch change when the
PITCH BEND data is received (0 to 12).
<PAGE 3>
EQ-Hi:
Sound correction in the high range.
∧ ∨
• Use the FC and buttons to adjust the standard fre-
∧
quency. Use the GAIN and
change.
EQ-Low:
Sound correction in the low range.
∧ ∨
• Use the FC and buttons to adjust the standard fre-
∧
quency. Use the GAIN and
change.
• The display looks similar to the following.
2.
Select the desired memory (A/B/C).
3.
Use the VARIATION buttons to select a varia-
tion.
4.
Press the START/STOP button.
• The DRUMS part begins to play back.
• The BASS and ACCOMP parts are played back when
you use the AUTO PLAY CHORD.
Composer
∨
buttons to set the ratio of
∨
buttons to set the ratio of
85
QQTG0701