Part VIII
4.
Select HIGH and use the
select H-FADE and use the
define the area of the higher range of tone out-
put.
• By entering different values for the H-FADE and HIGH
settings, you can define a sloping volume decrease from
the peak output which corresponds to the note pitch.
• By overlapping the L-FADE and H-FADE curves of each
different tone, you can achieve a cross-fade effect, where
the sound gradually changes in relation to pitch.
5.
Repeat steps 2 to 4 for the other tones, as
desired.
VELOCITY LAYER
Adjust these settings to regulate the tone output
relative to the velocity.
1.
Use the PAGE buttons to view the 3/4 display.
• The display looks similar to the following.
• Use the L and M buttons to select a setting item and
∧
∨
then the
and
buttons to specify a selection.
2.
Use the buttons to the left of the display to
select a tone (1st, 2nd, 3rd or 4th).
3.
Select L-FADE and use the
and select LOW and use the
to define the
sound output area for the
pp
lower range.
4.
Select HIGH and use the
select H-FADE and use the
define the
sound output area for the higher
ff
range.
• By overlapping the L-FADE and H-FADE curves of each
different tone, you can change the way the tone sounds
relative to how hard or softly the keyboard is played.
5.
Repeat steps 2 to 4 for the other tones, as
desired.
112
QQTG0701
∧
∨
and
buttons and
∧
∨
and
buttons to
∧
∨
and
buttons
∧
∨
and
buttons
∧
∨
and
buttons and
∧
∨
and
buttons to
TONE DYNAMICS
You can adjust the settings so that a different
sound (tone) is output for each tone depending
on the velocity (how hard the keys are played).
1.
Use the PAGE buttons to view the 4/4 display.
• The display looks similar to the following.
2.
Use the buttons to the left of the display to
select a tone.
Use the L and M buttons to select the column
3.
for the function you wish to adjust.
4.
Select the tone waveform.
∧
∨
• Use the GR
and
buttons to select the sound group.
Use the TONE WAVEFORM
the waveform.
∧
∨
5.
Use the LEV
and
buttons to adjust the vol-
∧
ume. Use the FLT
and
sound.
∧
6.
Use the VELOCITY
and
the velocity range.
• When the upper limit of a waveform is set to 127, no
more waveforms can be added.
7.
Repeat steps 3 to 6 to edit the other wave-
forms, as desired.
8.
Repeat steps 2 to 7 for the other tones, as
desired.
Sound Edit
∧
∨
and
buttons to select
∨
buttons to set the
∨
buttons to specify