Part Setting - Technics SX-PR54/M Operating Instructions Manual

Part VI

Part Setting

Set the various sound attributes for each part.
Selecting an attribute
1.
On the SOUND MENU display, select PART
SETTING.
2.
Use the PART SELECT
select the part.
<PAGE 1>
SOUND:
∧
Use the SOUND and
sound.
• The buttons on the control panel may also be used to
select a sound.
VOLUME:
∧ ∨
Use the VOL and buttons to adjust the vol-
ume (0 to 127).
PAN:
∧ ∨
Use the PAN and buttons to adjust the ste-
reo balance (L64–CENTER(CTR)–R63).
• At L64, the sound is completely to the left, at R63 com-
pletely to the right. At CENTER, the sound is at the cen-
ter. The display indicates the selected position.
• Even at the same numerical value, the stereo balance
may differ slightly depending on the sound.
SUS PEDAL:
∧
Use the SUSTAIN and
length of the sustain (1-8). Use the ON/OFF but-
tons to enable or disable the sustain effect, when
the sustain pedal is depressed.
KEY SHIFT:
∧ ∨
Use the KEY and
amount of key shift (−24 to +24).
• A value of 1 means a shift of one semi-tone. To raise (or
lower) the pitch one octave, set the value to +12 (or −12).
∨
• The button is used to lower the pitch, and the
to raise the pitch.
102
QQTG0701
∧ ∨
and buttons to
∨
buttons to select a
∨
buttons to adjust the
buttons to specify the
∧
button
3.
Use the buttons below the display to adjust
each attribute (explained in detail following).
• The settings display is comprised of 5 pages. Use the
PAGE buttons to switch pages.
4.
When you have completed adjusting all of the
settings for one part, select another part and
repeat the adjustment procedure as desired.
• The settings and effects of the PAN, EFFECT etc. may
differ depending on the sound.
TUNING:
∧ ∨
Use the TUNE and buttons to adjust the fine
tuning (−128 to +127).
∨
• The button is used to lower the pitch, and the
to raise the pitch.
<PAGE 2>
REVERB DEPTH:
∧
Use the REVERB and
depth of the REVERB (0 to 127).
DIGITAL EFFECT:
Use the DIG. EFFECT ON/OFF buttons to set
the DIGITAL EFFECT to on or off.
CHORUS:
Use the CHORUS ON/OFF button to set the
CHORUS to on or off. Use the
to adjust the depth of the effect (0 to 127).
MULTI:
Use the MULTI ON/OFF button to set the MULTI
EFFECT to on or off. Use the
adjust the depth of the effect (0 to 127).
<PAGE 3>
Sound
∧
button
∨
buttons to adjust the
∧ ∨
and buttons
∧ ∨
and buttons to