Technics SX-PR54/M Operating Instructions Manual page 103

Part VI
EQ LOW:
Use the EQ LOW FC, GAIN
adjust the sound quality in the lower range.
EQ HIGH:
Use the EQ HIGH FC, GAIN
adjust the sound quality in the upper range.
GLIDE PEDAL:
Use the GLIDE ON/OFF buttons to enable or dis-
able the glide effect, if it has been assigned to
the pedal.
• For pedal settings, refer to page 120.
ORIGINAL TUNING:
Use the ORIG ON/OFF button to enable or dis-
able the tuning for each sound.
• For details about ORIGINAL TUNING, refer to page 106.
<PAGE 4>
FILTER RESONANCE:
∧ ∨
Use the RESO and
amount of resonance (0 to 127).
ATTACK TIME:
∧ ∨
Use the ATT and
attack time (0 to 127).
DECAY TIME:
∧ ∨
Use the DEC and
decay time (0 to 127).
RELEASE TIME:
∧ ∨
Use the REL and
release time (0 to 127).
BRIGHTNESS:
∧ ∨
Use the BRI and buttons to adjust the bright-
ness of the sound (0 to 127).
VIBRATO RATE:
∧ ∨
Use the RATE and
vibrato speed (0 to 127).
VIBRATO DEPTH:
∧ ∨
Use the DEP and
vibrato depth (0 to 127).
VIBRATO DELAY:
∧ ∨
Use the DEL and buttons to specify the time
interval from when the keys are played until the
vibrato starts (0 to 127).
• The center value is 64 (±0).
∧ ∨
and buttons to
∧ ∨
and buttons to
buttons to adjust the
buttons to specify the
buttons to specify the
buttons to specify the
buttons to specify the
buttons to specify the
<PAGE 5>
MONO/POLY MODE:
∧
Use the MONO/POLY
the output mode.
PORTAMENTO:
Use the PORTAMENTO ON/OFF buttons to
enable or disable the portamento function. (Por-
tamento is a continuous gliding movement from
one tone to another.)
∧ ∨
Use the and buttons to specify the porta-
mento time.
• PORTAMENTO does not function for the POLY MODE.
MODULATION SENSITIVITY:
∧
Use the MOD SENS and
the sensitivity of the MODULATION (when MIDI
data is recieved).
∧ ∨
• Use the MSB and buttons (half-tone increments)
∧ ∨
and the LSB and buttons to adjust the setting.
BEND RANGE:
∧
Use the BEND RANGE
ify the PITCH BEND range (0 to 12). Increments
are in semi-tones.
• The higher the number, the greater the change in pitch
when PITCH BEND data is received as MIDI data.
Sound
∨
and buttons to select
∨
buttons to adjust
∨
and buttons to spec-
103
QQTG0701