Technics SX-PR54/M Operating Instructions Manual page 115

Part VIII
FILTER ENVELOPE
Specify how the filter changes over time, from
the time the key is played to the time the sound
dies out.
1.
Use the PAGE buttons view the 3/4 display.
• The display looks similar to the following.
• Use the L and M buttons to select a setting item and
∧ ∨
then the and buttons to specify a selection.
2.
Use the buttons to the left of the display to
select a tone.
∧ ∨
3.
Use the and buttons to modify the respec-
tive filter envelopes.
• Use the buttons below the display to adjust the respective
settings.
• You can select CUTOFF ADJUST and use the
buttons to set the total upper and lower settings, the
START POINT to set the start point, and the STOP
POINT to set the stop point.
4.
Repeat steps 2 and 3 for the other tones, as
desired.
FILTER ENVELOPE TOUCH & KEY
FOLLOW
Specify how the filter envelope (curve) changes
relative to touch or note pitch.
1.
Use the PAGE buttons to view the 4/4 display.
• The display looks similar to the following.
• Use the L and M buttons to select a setting item and
∧
then the
2.
Use the buttons to the left of the display to
select a tone.
3.
Modify how the respective filter envelopes
change relative to touch.
• Select TOUCH TIME and use the
∧ ∨
specify the time change, and select TOUCH LEVEL and
and
∧
use the
touch.
• At a − setting, the softer the keys are played, the greater
the change. At a + setting, the harder the keys are
played, the greater the change.
4.
Select KEY FOLLOW and use the
buttons to modify how the respective filter
envelopes change relative to note pitch.
• Adjust the respective slopes for attack, decay
release. Select CENTER and use the
specify the center of the bend slope by note name.
∨
and buttons to specify a selection.
∧
and
∨
and buttons to specify the level, relative to
∧
and
Sound Edit
∨
buttons to
∧ ∨
and
and
∨
buttons to
115
QQTG0701