Technics SX-PR54/M Operating Instructions Manual page 53

Part II
Recall the panel setup
1.
Use the BANK button to select a bank (A, B,
C).
2.
Press the desired PANEL MEMORY number
button (1 to 8).
• Turning the P.MEM 5-8 button ON enables the selection
of panel settings for numbers 5 to 8.
• The panel setup changes to the one stored in the speci-
fied memory.
• You can then change the sound settings, etc. manually;
however, the contents of the memory remain unchanged
until you store them again.
• The currently selected bank, memory number and mem-
ory name are shown in the top line on the normal display.
PANEL MEMORY mode
You can define which panel settings are recalled
when the PANEL MEMORY is used.
1.
Press and hold the SET button for a few sec-
onds.
• The display changes to the following.
2.
Select the mode.
NORMAL:
The sounds and volume balance, and CON-
DUCTOR status are stored.
EXPAND:
All the instrument's settings are stored, includ-
ing the rhythm (except for SOUND ARRANGER
on/off status), TRANSPOSE, tempo, etc.
• After a few seconds, the display exits the setting mode.
EXPAND MODE FILTER
You can specify which data is stored in the
EXPAND mode.
1.
Use the PAGE buttons to access the PAGE
2/3–3/3 EXPAND MODE FILTER display.
• The display looks similar to the following.
Use the ∧ and ∨ buttons to select the item.
2.
3.
Use the ON and OFF buttons to store the on
or off status for the selected item.
Playing the rhythm
53
QQTG0701