Technics SX-PR54/M Operating Instructions Manual page 77

Part III
4.
Use the ERASE DATA
specify the type of data to be erased.
ALL:
All data is erased.
NOTE:
Only note data is erased.
CONTROL:
Only control data (volume, effect and other
panel settings as well as selection changes)
is erased.
5.
Press the OK button.
• The confirmation display appears. Press the YES button
to execute the function, or press the NO button to cancel
the function.
MEASURE DELETE
Delete specified measures from a track.
• The length of the performance accordingly decreases by
the number of deleted measures.
∧
1.
Use the TRACK and
track from which measures are to be deleted.
• This function does not work for the CHORD or RHYTHM
track in which the repeat function has been stored.
• If ALL is selected, the specified measures are deleted
from all the tracks at one time.
2.
Use the FIRST MEAS
specify the first measure to delete.
3.
Use the LAST MEAS
specify the last measure to delete.
4.
Press the OK button.
• The confirmation display appears. Press the YES button
to execute the function, or press the NO button to cancel
the function.
∧ ∨
and buttons to
∨
buttons to select the
∧ ∨
and buttons, to
∧ ∨
and buttons to
MEASURE INSERT
Insert specified measures at a specified point.
• The length of the performance accordingly increases by
the number of inserted measures.
1.
Specify the measures you wish to copy from
the source track.
• On the FROM side, specify the settings with the corre-
sponding buttons.
TRACK:
Specify the track number you wish to copy
the measures from.
• This function does not work for the CHORD or
RHYTHM track in which the repeat function has been
stored.
• If ALL is selected, the measures are inserted in all
tracks at the same time.
FIRST MEASURE:
Specify the first measure to copy.
LAST MEASURE:
Specify the last measure to copy.
2.
Specify where you wish to insert the selected
measures.
• On the TO side, specify the settings with the correspond-
ing buttons.
TRACK:
Specify the track number.
• Measures from the CHORD, RHYTHM or CONTROL
track can only be inserted in the same track.
START MEASURE:
Specify the start point to insert the selected
measures.
REPEAT:
Specify the number of times the selected
measures are to be repeated.
3.
Press the OK button.
• The confirmation display appears. Press the YES button
to execute the function, or press the NO button to cancel
the function.
• Note that if the END command is included in the source
data, it is also inserted. Any data following the END com-
mand is not inserted.
Sequencer
77
QQTG0701