Pitch Edit - Technics SX-PR54/M Operating Instructions Manual

Part VIII

Pitch Edit

Adjust the settings related to the pitch of the sound.
KEY SHIFT & DETUNE
1.
On the SOUND EDIT menu display, select
PITCH.
• The display looks similar to the following.
• Use the L and M buttons to select a setting item and
∧ ∨
then the and buttons to specify a selection.
• Select ON/OFF and use the
ON or OFF.
2.
Use the buttons to the left of the display to
select a tone (1st, 2nd, 3rd or 4th).
3.
Select KEY SHIFT and use the
tons to specify the output pitch.
• Units are in semitones.
4.
Select DETUNE and use the
to fine-adjust the pitch.
• Slight differences in the DETUNE values between the
tones add fullness to the sound.
5.
Select TONE SCALE and use the
buttons to select the type of scale (NORMAL,
1/2, 1/4, 1/8, 1/16, 1/32, 1/64, FIX).
• NORMAL is the normal scale type. For example, when
1/2 is selected, a difference in pitch between one key and
the adjacent key becomes half the normal pitch differ-
ence. When FIX is selected, the pitch is the same regard-
less of which key is played.
PITCH ENVELOPE
Specify how the pitch changes over time, from
the time the key is played to the time the sound
dies out.
1.
Use the PAGE buttons to view the 2/3 display.
• The display looks similar to the following.
• Use the L and M buttons to select a setting item and
∧ ∨
then the and buttons to specify a selection.
2.
Use the buttons to the left of the display to
select a tone.
∧ ∨
and buttons to select
∧ ∨
and but-
∧ ∨
and buttons
∧ ∨
and
3.
Adjust the settings for the pitch change enve-
lope.
• Use the buttons below the display to set the correspond-
ing values. The envelope is created on the display as you
input the settings.
• Select TOTAL DEPTH and use the
specify the maximum level.
• Select START PITCH and use the
set the start point. Select STOP PITCH and use the
∨
and buttons to set the stop point.
4.
Repeat steps 2 and 3 for the other tones, as
desired.
PITCH ENVELOPE TOUCH & KEY
FOLLOW
Specify how the pitch envelope changes in rela-
tion to note pitch.
1.
Use the PAGE buttons to view the 3/3 display.
• Use the L and M buttons to select a setting item and
∧ ∨
then the and buttons to specify a selection.
2.
Use the buttons to left of the display to select a
tone.
∧
3.
Use the TOUCH and
the respective touch settings.
∧
• Select TIME and use the
time change depending on touch. Select LEVEL and use
∧ ∨
the and buttons to specify the pitch change level
depending on touch.
• At a − setting, the softer the keys are pressed, the greater
the change. At a + setting, the harder the keys are
pressed, the greater the change.
4.
Change the key follow settings for the
ATTACK, DECAY and RELEASE.
∧ ∨
• Use the and buttons corresponding to the ENVE-
LOPE KEY FOLLOW attributes to adjust the settings.
Select CENTER and use the
the center of the bend direction.
Sound Edit
∧ ∨
and buttons to
∧ ∨
and buttons to
∧
∨
buttons to change
∨
and buttons to specify the
∧ ∨
and buttons to select
113
QQTG0701