14.5 Remote switched connection.
The volt free connection on the rear of the stove can be used to provide a remote call for heat.
The product can be set up with a remote timeclock, room thermostats and motorised valves using the
standard S plan configuration where the auxiliary switch wires of the motorised valve can be connected to
the remote connections in place of the wires in the picture below providing a call for heat.
All electrical connections must be made by a competent electrician.
Note,
Connections are low voltage; a closed loop will call the stove. Remote connections should be designed to
switch infrequently to avoid excessive start up and shut down of the boiler.
Figure 30 – Remote connection
15 Performance graphs for the UPSO 15-55 CIAO circulating pump
Figure 31 – Performance graphs for the circulating pump
16 Life cycle of a Boiler pellet stove
Around 90% of the materials used in the manufacture of these stoves are recyclable, thus helping to reduce environmental impact
and contributing to the sustainable development of the Planet. End-of-life stoves should be returned to authorised waste
processing systems. We advise you to contact your local authorities for instructions.
33