Remote Control Operation; Heater Operation; Flame Operation - Stanley Argon Arranmore Installation And Operating Instructions Manual

Heater Operation

1. Press the Power button to start the flame
picture and the current room temperature will
be shown on the display.
2. Adjust the temperature to the desired setting
(15° to 30°C Range) using the Temp + &
Temp - buttons - See Fig 3.
NOTE: The set temperature must be above
the room temperature for the heating
function to operate.
3. Press the Heater button to select Full Heat
(2kW) and H2 with the red flame symbol
will be displayed
4. Press the Heater button again to select Half
Heat (1kW) and H1 with the orange flame
symbol will be displayed - see Fig 5.
On either heat setting, the heat function will turn off
when the room temperature reaches the set temper-
ature. The heat function will automatically restart
when the room temperature drops 3°C below the set
temperature.
5. Press the Heater button again to turn off the
Heater function.
NOTE: The fan will run for approximately 30
seconds after the Heating function is
turned off to remove any residual
heat for the unit to protect the control
components from any potential
overheating.

REMOTE CONTROL OPERATION

- see Fig 4.
8

Flame Operation

Press the Power button to start the flame
picture and the current room temperature will
be shown on the display. By pressing the Flame
Picture button, you can select from four different
Flame Picture options:
-- No Flame Picture
FE Flame & Logs
-E Logs Only
F- Flame Only
NOTE: When one of these modes has been
selected, this mode will be the default
mode when the unit is turned on by
manual or remote operation.
The brightness setting of the Flame Picture can also
be adjusted by pressing the Brightness button to
select from the following levels:
H - Maximum Setting
C - Intermediate Setting
L - Minimum Setting