Installation Requirements; Installation Of Ducts And Fume Extraction Systems; Installation Without A Chimney - Stanley K1700 Installation And Operating Instructions Manual

7

Installation requirements

The minimum distance between the free-standing pellet fire stove and particularly flammable surfaces is specified in
Figure 11.
The top of the stove must be at least 100cm separated from the ceiling, especially in rooms with ceilings consisting of
flammable materials.
The base supporting the stove cannot be made of combustible material (e.g. carpet), so make sure you use an adequate
protection.
Figure 11 – Clearances to combustibles: a) plan view of the stove's installation;
7.1

Installation of ducts and fume extraction systems:

·
The exhaust pipe must have been designed for this purpose, in compliance to the location requirements and in accordance
with any applicable regulations.
·
Important! An inspection-T with an airtight lid must be attached to the exhaust pipe of the stove to allow the regular
inspection of the system or discharge of heavy dust and condensates. As indicated in Figure 15, the exhaust pipe must be
assembled to allow cleaning and maintenance of the pipe by inserting inspection points.
·
Under normal operating conditions, the combustion gas flow should create a draught of 12 Pa one meter above the chimney
neck.
·
The stove must be installed in a shared chimney
·
Pipes outside the heated area must be suitably insulated
7.2

Installation without a chimney

The installation of the boiler pellet stove without a chimney should be performed as illustrated in Figure 16, with 100 mm diameter
flue pipe up to the Tee piece for the boiler model) directly outside and over the roof.
Double-walled stainless- s t e e l insulated pipes must be used and properly fastened to avoid condensation.
A T-tube must be installed at the base of the pipe to allow periodic inspections and annual maintenance, as illustrated in
Figure 16.
a)
b) side view of the stove's installation
b)
11