Adjust Track Tension - Ariens Sno-Thro Compact 24 Operator's Manual

4. With traction clutch disengaged, check
that swing gate tab touches the front edge
of stop hole. See Figure 36.
IMPORTANT: Swing gate tab MUST touch
stop hole edge. Readjust cable as necessary
until tab touches stop hole edge.
1. Swing Gate Tab
2. Stop Hole
Figure 36
5. Reconnect spark plug wire.

ADJUST TRACK TENSION

Model 920022
1. Check tension by applying pressure to
track between the upper and rear track
rollers. Deflection should be
approximately 9.5 mm (3/8"). See
Figure 37.
Figure 37
2. Adjust tension as needed with track
adjusters. Tighten nut to increase tension;
loosen nut to decrease tension. See
Figure 38.
1
2
Apply pressure here.
If unit does not travel correctly, adjust track
tension. See Figure 38.
• If unit pulls to the left, tighten the left track
adjuster.
• If unit pulls to the right, tighten the right
track adjuster.
EN - 22
Adjust here.
Figure 38