Connector Pin Assignment - Mitsubishi Electric MDS-E Series Instruction Manual

MDS-E/EH Series Instruction Manual
2 Wiring and Connection

2.2.2 Connector Pin Assignment

CAUTION
Do not apply a voltage other than that specified in Instruction Manual on each terminal. Failure to observe this item could
lead to rupture or damage, etc.
(1) Main circuit terminal block and connector
Power supply unit
Unit
Terminal
Terminal
position
[1] TE1
Terminal
specification/
Pin
assignment
[2] TE2
[3] TE3
[4]
(Note) The illustrations of drive units are shown as an example.
MDS-E-CV-37 to 75
[2]
[3]
[4]
[1]
L3
L2
L1
(Note) This is a bottom view.
L+
Screw size
L- Tightening torque
Compatible unit
L11
L21
Screw size
Tightening torque
Screw size: M4×12
Tightening torque: 1.2Nm
49
MDS-E-CV-110 to 185
MDS-EH-CV-37 to 185
L1 L2 L3
Compatible unit
Screw size
Tightening torque
Compatible unit
All of CV
M6 x 18
4.0Nm
All of CV
M4 × 10
1.2Nm
The PE screw size is the same as TE1.
[2]
[3]
[1]
[4]
All of CV
M5 x 12
2.0Nm
IB-1501229-F