1747464-1 Plug Connector; Applicable Products; Applicable Cable; Related Documents - Mitsubishi Electric MDS-E Series Instruction Manual

MDS-E/EH Series Instruction Manual
10 Appx. 1: Cable and Connector Assembly

10.2 1747464-1 Plug Connector

10.2.1 Applicable Products

10.2.2 Applicable Cable

Refer to Product Specification and Application Specification for details.

10.2.3 Related Documents

10.2.4 Assembly Procedure

Assemble the cable in the following procedure:
(1) Insert accessories to the cable.
(2) Remove the sheath of the cable jacket and core wires referring to the typical
dimensions in the right figure.
Do not damage the core wires. Retry it if the core wires are partly cut off or
damaged.
The length of mesh shield should be decided referring to the right figure and be
turned up on the outside of a jacket.
(Note) Even when the dimensions above is applied,
product performance problem can occur depending on the wires which is used.
Be sure to contact with the sales department of the manufacturer below if you consider to adopt this
connector.
Tyco Electronics Japan G.K. http://www.te.com/en/home.html
(3) Twist a copper foil tape with conductive adhesive of width 5mm around the mesh
shield.
Cable finish outside diameter: Φ7.3 to 7.7
(4) Refer to Application Specification (114-5335) and crimp the contacts. After crimping,
check the state in accordance with the Specification.
IB-1501229-F
Part No.
1674320-1
1674320-2
1674335-4
Wire conductor size Cable jacket outside diameter
#26-22AWG
No.
108-5864
114-5335 Rec, Contact Application Specification
114-5338 Ground Clip Application Specification
470
Descriptions
Encoder cable I/O kit
Receptacle contact
6.8 to 7.4 mm
Details
Product Specification
Receptacle case assembly
1.6 to 2.0mm
Wire fixed set screw
Wire clamp
Wire rubber packing
Ground clip
Cable
Far side
Mesh shield
16±1mm
4 to 5mm
1.6 to 2.0mm
14±1mm
Near side
Copper foil tape
Φ7.3 to 7.7
6mm MAX
Receptacle contact