Revision History - Mitsubishi Electric MDS-E Series Instruction Manual

Date of revision Manual No.
Feb. 2015 IB(NA)1501229-A
May. 2015 IB(NA)1501229-B
Mar. 2016 IB(NA)1501229-C

Revision History

First edition created.
- "Precautions for Safety" was revised.
- SJ-DG Series spindle motors were added.
- Function Specifications List was revised.
- "Shaft Characteristics" in "Installation of Spindle Motor" was revised.
- The pictures of NC in following chapters were changed to the ones of M800.
"Spindle Side PLG Serial Output Encoder (TS5690, MU1606 Series)", "STO
(Safe Torque Off) Function", "Spindle Motor Temperature Compensation
Function".
- "Connector Pin Assignment" was revised.
- "Main Circuit Connector (TE1) Wiring Method" was revised.
- "Connection of the Servo Motor" and "Connection of the Spindle Motor" were
revised.
- "Input/Output Circuit Wiring" was revised.
- "STO (Safe Torque Off) Function" was revised.
- "Servo Parameters" was revised.
- "Setting the Initial Parameters for the Spindle Drive Unit" was revised.
- "List of Standard Parameters for Each Spindle Motor" was revised.
- "Spindle Parameters" was revised.
- "Standard VGN1 graph" was added to "Speed Loop Gain".
- "Position Loop Gain" was revised.
- "Optimal Adjustment of Cycle Time" was revised.
- "Improvement of Characteristics during Acceleration/Deceleration" was
revised.
- "Overload Detection" was revised.
- "Gain Adjustment" was revised.
- "List of Alarms" was revised.
- "OSA105" was replaced by "OSA405".
- "OSA166" was replaced by "OSA676".
- "OSA18" was replaced by "OSA24RS".
- "List of Warnings" was revised.
- "Troubleshooting for Each Alarm No." was revised.
- "Troubleshooting for Each Warning No." was revised.
- "Replacing the Unit Fan" was added.
- "Replacing the Battery" was revised.
- "Wiring of Retraction Function at Power Failure" was revised.
- Miswrite is corrected.
- Revisions were made to support MDS-E-V3 Series.
- Specification descriptions of servo motor HG75, HG105, HG-H75, and HG-
H105 were added.
- Servo motor HG46, HG56, HG96, and HG-H1502 were added.
- The following spindle motors were deleted.
SJ-VS7.5-14FZT,SJ-VKS26-09FZT,SJ-VKS30-16FZT,SJ-VLS15-11FZT,
SJ-4-V3.7-05ZT,SJ-4-V11-23ZT,SJ-4-V15-18T,SJ-4-V37-04ZT,
SJ-4-V11-21T,SJ-4-V18.5-17T
- Descriptions for tool spindle motor were added.
- "Precautions for Safety" was revised.
- Function Specifications List was revised.
- "Quakeproof Level", "Shaft Characteristics", "Oil / Water Standards" and
"Installation of Servo Motor" in "Installation of Servo Motor" were revised.
- "Installation of Spindle Motor" was revised.
- "Balancing the Spindle Motor (Unit)" was revised.
Revision details