Fiat Fremont 2013 Owner's Handbook Manual page 72

Table of Contents

Advertisement

9. Passenger Temperature Control Down Button
KNOWING
Provides the passenger with independent temperature
YOUR
control. Push the button for cooler temperature set-
VEHICLE
tings.
NOTE: Pressing this button while in Sync mode will
SAFETY
automatically exit Sync.
10. SYNC
STARTING
Press the Sync soft-key to toggle the Sync feature
AND
On/Off. The Sync indicator is illuminated when this
DRIVING
feature is enabled. Sync is used to synchronize the
WARNING
passenger temperature setting with the driver tem-
LIGHTS
perature setting. Changing the passenger temperature
AND
setting while in Sync will automatically exit this feature.
MESSAGES
11. Blower Control
IN AN
Blower control is used to regulate the amount of air
EMERGENCY
forced through the climate system. There are seven
blower speeds available. Adjusting the blower will
SERVICING
cause automatic mode to switch to manual operation.
AND
The speeds can be selected using either hard-heys or
CARE
soft-keys as follows:
Hard-key
TECHNICAL
SPECIFICATIONS
The blower speed increases as you turn the control
clockwise from the lowest blower setting. The blower
speed decreases as you turn the knob counter-
CONTENTS
clockwise.
66
Soft-key
Use the small blower icon to reduce the blower setting
and the large blower icon to increase the blower
setting. Blower can also be selected by pressing the
blower bar area between the icons.
12. Modes
The airflow distribution mode can be adjusted so air
comes from the instrument panel outlets, floor outlets,
demist outlets and defrost outlets. The Mode settings
are as follows:
• Panel Mode
Air comes from the outlets in the instrument
panel. Each of these outlets can be individually
adjusted to direct the flow of air. The air vanes of the
center outlets and outboard outlets can be moved up
and down or side to side to regulate airflow direction.
There is a shut off wheel located below the air vanes to
shut off or adjust the amount of airflow from these
outlets.
• Bi-Level Mode
Air comes from the instrument panel outlets
and floor outlets. A slight amount of air is
directed through the defrost and side window demister
outlets.

Advertisement

Table of Contents
loading

Table of Contents