Table of Contents
Advertisement
If the tire inflates to the recommended pres-
KNOWING
sure or is at least 1.8 Bar pressure within 15
YOUR
minutes:
VEHICLE
1. Press the Power Button (4) to turn off the TIREFIT
kit.
SAFETY
2. Remove the Speed Limit sticker from the top of the
Sealant Bottle (1) and place the sticker on the
STARTING
instrument panel.
AND
3. Immediately disconnect the Sealant Hose (6) from
DRIVING
the valve stem, reinstall the cap on the fitting at the
WARNING
end of the hose, and place the TIREFIT kit in the
LIGHTS
vehicle storage location. Quickly proceed to (D)
AND
MESSAGES
"Drive Vehicle".
IN AN
• The metal end fitting from Power Plug
EMERGENCY
(8) may get hot after use, so it should be
handled carefully.
SERVICING
• Failure to reinstall the cap on the fitting at the
AND
end of the Sealant Hose (6) can result in sealant
CARE
contacting your skin, clothing, and the vehicle's
interior. It can also result in sealant contacting
TECHNICAL
internalTIREFIT kit components which may cause
SPECIFICATIONS
permanent damage to the kit.
(A) Whenever You Stop To Use TIREFIT:
CONTENTS
1. Pull over to a safe location and turn on the vehicle's
Hazard Warning flashers.
260
2. Verify that the valve stem (on the wheel with the
deflated tire) is in a position that is near to the
ground. This will allow the TIREFIT Hoses (6) and
(7) to reach the valve stem and keep the TIREFIT kit
flat on the ground. This will provide the best posi-
tioning of the kit when injecting the sealant into the
deflated tire and running the air pump. Move the
vehicle as necessary to place the valve stem in this
position before proceeding.
3. Place the transmission in PARK (auto transmission)
or in Gear (manual transmission) and turn Off the
ignition.
4. Set the parking brake.
(B) Setting Up To Use TIREFIT:
1. Turn the Mode Select Knob (5) to the Sealant Mode
position.
2. Uncoil the Sealant Hose (6) and then remove the
cap from the fitting at the end of the hose.
3. Place the TIREFIT kit flat on the ground next to the
deflated tire.
4. Remove the cap from the valve stem and then screw
the fitting at the end of the Sealant Hose (6) onto
the valve stem.
5. Uncoil the Power Plug (8) and insert the plug into
the vehicle's 12 Volt power outlet.
Advertisement
Table of Contents
