Table of Contents
Advertisement
4. After the engine starts, allow it to idle for approxi-
KNOWING
mately 30 seconds before driving. This allows oil to
YOUR
circulate and lubricate the turbocharger.
VEHICLE
To Turn Off The Engine Using ENGINE
START/STOP Button
SAFETY
1. With the vehicle stopped, place the shift lever in
NEUTRAL/PARK, then press and release the EN-
STARTING
GINE START/STOP button.
AND
DRIVING
2. The ignition switch will return to the OFF position.
WARNING
NOTE:
LIGHTS
• If the ignition switch is left in the ACC position, the
AND
system will automatically time out after 30 minutes
MESSAGES
of inactivity and the ignition will switch to the OFF
IN AN
position.
EMERGENCY
• If the ignition switch is left in the RUN position, the
system will automatically time out after 30 minutes
SERVICING
of inactivity if the vehicle speed is 0 km/h and the
AND
engine is not running.
CARE
• If the shift lever is not in PARK and the vehicle speed
is above 8 km/h, the ENGINE START/STOP button
TECHNICAL
SPECIFICATIONS
must be held for two seconds before the engine
shuts off. The ignition switch position will remain in
the ACC position until the vehicle is stopped and the
CONTENTS
button is pressed twice to the OFF position.
206
Turbocharger "Cool Down"
NOTE: Letting the engine idle after extended opera-
tion allows the turbine housing to cool to normal
operating temperature.
The following chart should be used as a guide in
determining the amount of engine idle time required to
sufficiently cool down the turbocharger before shut
down, depending upon the type of driving and the
amount of cargo.
Advertisement
Table of Contents
