Table of Contents
Advertisement
7. Align the index tabs of the replacement rear fog
KNOWING
lamp bulb/socket assembly with the slots in the
YOUR
collar of the bulb opening on the back of the lamp
VEHICLE
housing.
8. Insert bulb into the lamp housing until the index
SAFETY
tabs are engaged in the slots of the collar.
9. Firmly and evenly push the bulb straight into the
STARTING
lamp housing until both side latches lock firmly into
AND
place.
DRIVING
10. Reinstall the fog lamp housing.
WARNING
LIGHTS
SIDE REPEATER LAMP
AND
The side repeater lamps are located in both front
MESSAGES
fender panels.
IN AN
1. Push the side repeater lens to left side to release the
EMERGENCY
spring tension and then pull it outward.
2. Disconnect the bulb from the harness connector
SERVICING
and then connect the replacement bulb. (fig. 165)
AND
CARE
3. Engage the right hook of the side repeater lamp into
the sheet metal (note correct orientation of letter-
ing on lens).
TECHNICAL
SPECIFICATIONS
4. Rotate the side repeater lamp in place until the left
side engages (you will hear a light click).
CONTENTS
268
REAR TURN SIGNAL AND BACKUP LAMP
The taillamps are a two-piece design. The tail/stop/rear
turn signal lamps are located in the rear corner body
panels. The tail and backup lamps are located in the
liftgate.
Changing The Rear Turn Signal Lamp
1. Open the liftgate.
2. Remove the two fasteners from the inboard side of
the taillamp housing. (fig. 166)
3. Carefully insert a trim stick (plastic flat-blade tool)
between the body panel and the outboard side of
the taillamp housing with one hand and grasp the
flange on the inboard side of the taillamp housing
(fig. 165)
Side Repeater Bulb Removal
Advertisement
Table of Contents
