Table of Contents
Advertisement
Rear of the Drive,
The drive is configured as a Single. If you want to operate a second drive on this
Configuration
bus, you have to set either one of them as Master and the other as Slave or vice
versa.
FACTORY USE ONLY
SINGLE
7
DIGITAL OUT
Connect a cable to this output to transfer Digital Audio data to appropriate audio
Connector
devices.
8
Line Out
Connect a cable to this output to transfer analog Audio data.
Connector
9
Jumper Block
This block of jumper locations sets the configuration for the CD-ROM drive.
B
These plug-in jumpers are used to configure the CD-ROM drive.
10 I/O-Bus
This BUS connector is used to connect a data/control line. Use a flat ribbon cable
Connector
to connect your CD-ROM drive to the IDE controller.
11 Power
Connect the power supply cable to this connector.
Connector
RI 45 PIII, Manual
C79000-G7076-C817-01
DIGITAL
LINE
OUT
OUT
JUMPER
BLOCK
DIG GND
R GND L
1 2 3
7
8
9
CD-ROM Drive
I/O BUS
+5V
GND
10
+12V
11
4-3
Advertisement
Table of Contents
