Table of Contents
Advertisement
SCSI Option
7.3.4
Advanced Configuration Options
Plug and Play
You can use this setting to specify whether or not the ID management at the
SCAM Support
SCSI bus is to be carried out automatically by the host controller. (SCSI
Configured Automatically protocol (SCAM))
Disabled
Enabled
Reset SCSI Bus at
If you have enabled this menu option, the SCSI bus is reset.
IC
Enabled
Disabled
Extended BIOS
When this function is enabled, you can operate drives of up to 8 Gbyte
Translation for
capacity (2 Gbytes per partition) under MS-DOS 5.0 or a later version. The
DOS Drives >
SCSI BIOS must be enabled for this purpose.
1Gbyte
Formerly, only drives with a capacity of up to 1 Gbyte could be operated
under DOS 5.0.
Enabled
Disabled
Note
Save the data on your hard disk before you change the default setting. After
switching on you must repartition and format the hard disk with the
MS-DOS programs FDISK and FORMAT.
7-10
No automatic ID management (default setting).
The SCSI controller sends SCAM commands. Most devices
without SCAM capabilities tolerate SCAM commands. If
problems should arise, reset to Disabled.
SCSI bus is reset (default setting).
SCSI bus is not reset.
Drives of up to 8 Gbytes can be operated under MS-DOS 5.0
(default setting).
Drives of up to 1 Gbyte can be operated under MS-DOS 5.0.
RI 45 PIII, Manual
C79000-G7076-C817-01
Advertisement
Table of Contents
