Siemens SIMATIC RI 45 PIII Series Manual page 81

Table of Contents

Advertisement

Hard Disk
Timeout
Figure 2-25"Power" Submenu
Fan Control
Power Fail
Restart
Resume on
Modem Ring
Resume On
Time
Resume Time
RI 45 PIII, Manual
C79000-G7076-C817-01
[Disabled]
[10, 15, 30, 60]
PhoenixBIOS Setup-Utility
Main
Advanced
Security
Power
[ Enabled ]
APM:
[ Disabled ]
Power Savings:
Standby Timeout:
Off
Suspend Timeout:
Off
Hard Disk Timeout:
Disabled
Enabled
Fan Control:
Resume On Modem Ring:
[ Off ]
Resume On Time:
[ Off ]
[ 00:00:00 ]
Resume Time:
[ Enabled ]
Power Fail Restart:
F1
Help
Select Item
+ / –
ESC
Exit
Select Menu
Enter Select
Enabled
Disabled
Enabled
Disabled
[On]
[On]
[Off]
Motherboard
Hard disks are not switched off.
Minutes after which the hard disk drive is
switched off, provided it is not being accessed.
If you attempt to access the hard disk after it
has been switched off, there will be an access
delay while the disk is run up again.
Boot Sequence
Version
Item Specific Help
Maximum Power Savings conserves
the greatest amount of system power.
Maximum Performance conserves
power but allows greatest system
performance. To alter these settings,
choose Customized. To turn of power
management, choose Disabled.
Enabled
Disabled
Change Values
F9
Setup Defaults
Sub-Menu
F10
Save and Exit
Fan RPM vary according to temperature.
Fan always runs at a high RPM.
The device turns itself back on after a power
outtage if the device was on at the time.
The device does not turn itself back on after a
power outtage.
The "RING" signal allows a modem to be
woken up from Suspend Mode.
This function allows the PLC to be
automatically turned back on at a time entered
below.
This function is disabled with Off
Time of automatic startup.
Exit
2-53

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simatic ri 45 piii tower

Table of Contents