12.8 Belt Tensioning Block
If the tensioning block is to be replaced, the product key must be indicated.
Example: HMRB15CBD0-1200-000000000
To ensure that a suitable tension block can be delivered, the following must be known at the very least:
Drive type B = Belt
•
•
Product size (15 = width 150 mm)
•
Motor mounting position (BD = 090° front double plain shaft)
•
Carriage: (0 = Standard)
Order number tension block Belt Drive
Type of drive
HMRB08xBD..., HMRB08xDD...
HMRB08xAP..., HMRB08xCP..., HMRB08xAD..., HMRB08xCD...
HMRB11xBD..., HMRB11xDD...
HMRB11xAP..., HMRB11xCP..., HMRB11xAD..., HMRB11xCD...
HMRB15xBD..., HMRB15xDD...
HMRB15xAP..., HMRB15xCP..., HMRB15xAD..., HMRB15xCD...
HMRB18xBD..., HMRB18xDD...
HMRB18xAP..., HMRB18xCP..., HMRB18xAD..., HMRB18xCD...
HMRB24xBD..., HMRB24xDD...
HMRB24xAP..., HMRB24xCP..., HMRB24xAD..., HMRB24xCD...
Clamping plate
Tension pin
Pusher
53
Toothed belt lock
Comments
Motor mounting 090/270, Standard
Motor mounting 000/180, Standard/Bipart
Motor mounting 090/270, Standard
Motor mounting 000/180, Standard/Bipart
Motor mounting 090/270, Standard
Motor mounting 000/180, Standard/Bipart
Motor mounting 090/270, Standard
Motor mounting 000/180, Standard/Bipart
Motor mounting 090/270, Standard
Motor mounting 000/180, Standard/Bipart
EN
Tighten plate
Order number
56219FIL
56220FIL
56221FIL
56222FIL
56162FIL
56163FIL
56164FIL
56165FIL
56166FIL
56167FIL